How to Draw a Circle Given Three Points

Download Article

Reviewed by Joseph Meyer

Last Updated: June 25, 2025 References

Download Article

Setting up the Points

|

Drawing Perpendicular Bisectors

|

Drawing the Circle

|

Video

A circle is defined by any three non-collinear points.^{[1]
X
Research source} This means that, given any three points that are not on the same line, you can draw a circle that passes through them. It is possible to construct this circle using only a compass and straightedge.

Part 1

Part 1 of 3:

Setting up the Points

Download Article

1
Draw your three points. If you have the coordinates of the points, map them on a coordinate plane. If you are not working with specific points, you can draw your own on a piece of paper.
- For example, you might draw points A, B, and C in any position you'd like.
2
Determine whether your points are noncollinear. Noncollinear means that they are not on the same line. You can draw a circle from any three points, as long as they are not on the same line.
- If you aren’t sure whether the points are collinear, lay a straightedge across them. If the straightedge passes through all three points, the points are collinear, and you cannot use them to draw a circle.
Advertisement
3
Draw two line segments between any two sets of points. Use a straightedge to connect all of the points.^{[2]
X
Research source}
- For example, you might draw line segments AB and BC.

Part 2

Part 2 of 3:

Drawing Perpendicular Bisectors

Download Article

To do this, place the compass tip on the first endpoint. Open the compass to a little more than halfway across the line segment. Draw an arc across the line segment.^{[3]
X
Research source}
2
Draw an arc centered at the second endpoint. Without changing the width of the compass, place the compass tip on the second endpoint. Draw a second arc across the line segment.^{[4]
X
Research source}
- The two arcs should intersect above and below the line.
Line up a straightedge with the intersection of the arcs above the line, and the intersection of the arcs below the line. Draw a line connecting these two points. The line you draw is a perpendicular bisector. It bisects the line at a right angle.^{[5]
X
Research source}
Use a compass and straightedge to construct the bisectors as you did with the first line segment.^{[6]
X
Research source} Extend the bisectors long enough that they intersect. The point of their intersection is the center of the circle.^{[7]
X
Research source}

Part 3

Part 3 of 3:

Drawing the Circle

Download Article

1
Set the compass width to the circle’s radius. The radius of a circle is the distance from the center to any point on the circle’s edge.^{[8]
X
Research source} To set the width, place the tip of the compass on the center of the circle, and open the compass to any one of your original points.^{[9]
X
Research source}
- For example, you might set the tip of the compass on the circle center, and reach the pencil to point B.
Swing the compass around 360 degrees so that it draws a complete circle. The circle should pass through all three points.
For a neat circle, make sure to erase your line segments, arcs, and perpendicular bisectors.